leftadv.blogg.se

Honda lamp logos ihex auto 2 pcs
Honda lamp logos ihex auto 2 pcs




honda lamp logos ihex auto 2 pcs
  1. #Honda lamp logos ihex auto 2 pcs install#
  2. #Honda lamp logos ihex auto 2 pcs software#
  3. #Honda lamp logos ihex auto 2 pcs windows#

2 x female spade connector terminals (6.3mm).5 x blanking seals (where only 2 terminals are used in a 3-wire connector).5 x male MT-3 connector kit including pins and wire seals.3 x female MT-3 connector kit including pins and wire seals.

honda lamp logos ihex auto 2 pcs

  • 1 x 1.5m 2-core extension cable with spade connectors on one end (typically used to connect air horns or other 2-wire accessories).
  • 1 x 0.5m 3-core extension cable (typically used for brake lights).
  • 2 x 1.5m 3-core extension cables (typically used for 2-wire or 3wire front accessory lights).
  • The HEX ezCAN Extension Harness Kit provides you with everything that you need to connect your auxiliary lights, brake lights and horn to the ezCAN, with additional connectors to facilitate other accessories. This device works on the following Honda models:

    #Honda lamp logos ihex auto 2 pcs windows#

  • Plug accessories into the ezCAN and configure via USB (Mac or Windows PC).
  • Route and plug the ezCAN into the motorcycle CAN-bus.
  • Route and connect the ezCAN battery cables.
  • #Honda lamp logos ihex auto 2 pcs install#

    Install the ezCAN under the seat or side panel.

    #Honda lamp logos ihex auto 2 pcs software#

  • Download and install the configuration software.
  • Four individually electronically fused channelsĮASY INSTALLATION.
  • Easy configuration of software via USB (Mac and Windows PC).
  • Unobtrusive – fits perfectly under the seat.
  • Plugs directly into CAN-Bus (saves installation time and wiring complexity).
  • It’s simple and easy to fit additional lights, an air horn, accessories and emergency brake lights that make the bike safer to ride.Ĭustomise your bike and make it safer to ride. The HEX ezCAN accessory manager lets you add and configure accessories with ease and without cutting any wires. The power to manage your accessories safely. It provides you with a highly configurable, seamless plug and play solution to add accessories to your bike without the need to cut any wires that could void your warranty!
  • Imported from USA (Sizes & Specifications are based on the USA Market).The ezCAN plugs directly into your CRF1100 Africa Twin and listens to CAN-bus.
  • PRODUCT FEATURES: 3W power, 12V DC voltage, IP66 waterproof rate, built-in CanBus controller, complete no onboard computer error, 30000 long life span.
  • honda lamp logos ihex auto 2 pcs

    Meanwhile, the housing with ultra sonic heating and with high waterproof, no worry about the light would be damaged by outside water either.

  • 150° ADJUSTABLE ANGLE: The projection logo angle can be adjustable by the screw(trun left or right) on the back of the light, so you don't worry about the fixed problem.
  • Also, the default projection logo is the car logo.
  • BRIGHT HD PROJECTION: Using the high brightness LED CREE chip which means that it features a high definition and super bright lighting output, and very low consumption as well.
  • Also, please note that this product only used for replacing your original side mirror light, if your original side mirror without light, please do not buy, it will be big problem for the installation. 100% plug and play, No drilling, No rewiring, and you don't need the transfer wire either.
  • EASY TO INSTALL: Installation is very simple, directly replace the original side mirror lights.





  • Honda lamp logos ihex auto 2 pcs